Skip to content
Mon–Sat, 10:00 AM – 5:30 PM +91 93630 47778

Misting · Industrial

Odour Control Misting Systems

Neutralise smells at the boundary, not after the complaints arrive. Our high-pressure misting systems atomise an odour-neutralising solution into droplets fine enough to meet and bind odour molecules in the air.

Odour Control Misting Systems

How misting helps: odour control

Odour problems at waste transfer stations, sewage treatment plants, compost yards, slaughterhouses and food factories rarely stay inside the fence. A misting system puts a curtain of very fine droplets along the boundary, over open tanks or inside exhaust ducts. Because the droplets are around 10–20 microns, they stay airborne long enough to contact odour compounds while using very little liquid.

We design each system around the source, prevailing wind and the neutraliser you choose — plant-based neutralisers, masking agents or plain water for dust-borne odours — with a dosing pump that keeps the concentration steady.

  • Municipal waste transfer stations and landfills
  • Sewage and effluent treatment plants
  • Compost and biomethanation yards

Boundary curtains

Nozzle lines on the fence or roof edge treat air before it leaves the site.

Accurate dosing

A proportional dosing pump mixes neutraliser at a fixed ratio, so you do not waste chemical.

What you get

Benefits

Boundary curtains

Nozzle lines on the fence or roof edge treat air before it leaves the site.

Accurate dosing

A proportional dosing pump mixes neutraliser at a fixed ratio, so you do not waste chemical.

Very little wetting

Fine droplets evaporate quickly — surfaces and workers stay dry.

Automatic control

Timers, wind sensors or PLC signals run the system only when it is needed.

Technical details

Typical system specification

Every system is sized after a survey; these are typical values.

ParameterTypical value
Pump pressureAbout 70 bar (1,000 psi) high-pressure plunger pump
NozzlesBrass or stainless body, 0.15–0.30 mm stainless/ruby orifice, 10/24 UNC thread, anti-drip check valve
DosingProportional dosing pump, 0.1–2% neutraliser ratio
ControlTimer, wind-direction sensor or PLC interface
Water treatment5-micron sediment filter as standard; softener for hard borewell water

Applications

Where it is used

  • Municipal waste transfer stations and landfills
  • Sewage and effluent treatment plants
  • Compost and biomethanation yards
  • Slaughterhouses and rendering units
  • Food, dairy and fish processing
  • Paper mills and tanneries

Process

How we deliver it

  1. Survey & map

    We map odour sources, wind direction and sensitive neighbours.

  2. Choose the approach

    Boundary curtain, open-tank coverage or in-duct rings — with the neutraliser you prefer.

  3. Install & dose

    Pump, dosing system and lines are installed and set to the right ratio.

  4. Review

    We review results with you after the first weeks and adjust timing.

FAQs

Frequently asked questions

Is the neutralising liquid safe for workers?

We only recommend neutralisers whose safety data sheets allow use in occupied areas, and we set the dosing ratio to the supplier’s guidance. You choose the product; we size the system to it.

Can misting remove all odour?

It can reduce odour strongly at the boundary, but it works best alongside good housekeeping such as covering waste and controlling leachate. We will tell you honestly what to expect after the site survey.

How much neutraliser does it use?

Typically a few litres of concentrate per day for a 100 m boundary line, depending on run hours and ratio. We estimate it for your site before you order.

Can it be installed inside exhaust ducts?

Yes. Nozzle rings inside ducts or around fans treat the air stream before it is released.

Related

More industrial applications

Industrial high pressure

Industrial high pressure

Cool large sheds, loading bays and hot work zones by several degrees using flash evaporation, at a fraction of the power of air-conditioning..

See system
Adiabatic cooling kit

Adiabatic cooling kit

Air-cooled chillers and condensers lose capacity on the hottest afternoons.

See system

Planning odour control misting?

Share photos and rough dimensions on WhatsApp. We will reply with a layout idea and a ballpark cost, usually the same working day.